![]() ![]() I recognize that this is a long shot, thanks. However, the VB175 works fine with the above method. Is it possible that early DDC/CI monitors did not support this specific functionality? I'm also running an Asus VB175 which by the look of it is a monitor that came out around the same as the DELL 1908FP. I have tried the connection in two ways, one via DisplayPort to DVI, and one with DVI to Analog, both of which yield no results. Other functionality such as changing the brightness, contast, color, etc seem to work. ![]() However, changing the **bleep** Power Mode D6 from 1 to 4 via software methods seems to have no effect, and I can't determine why. Monitors Dell UltraSharp 1908FP 19' SXGA LCD Monitor, 5:4, Black. This was determined via ControlMyMonitor from NirSoft by running the app with the monitor on and off. In this scenario, I've determined that a **bleep** of 1 is on, and 4 is off. Now, the Capabilities string claims that it supports D6 which is the Power Mode. You can benefit from consistent and accurate colors across a wide 5:4 aspect ratio that features an ultra-wide 160°/160° viewing angle. The 1908FP 19' Fullscreen LCD Monitor from Dell offers 1280 x 1024 resolution at 75 Hz and a 300 cd/m2 typical brightness. I have done that and will edit this post with it in a minute. Black Dell 1908FP 19' 1280x1024 5:4 LCD Monitor DVI VGA USB Grade B. In order to do this, one must obtain the Capabilities string of the monitor over C++, then follow this tutorial. I am attempting to control this DELL 1908FP via software over the supposed DDC/CI it supports. This is a very specific question, but it's worth a try.
0 Comments
Leave a Reply. |